Audiovox SBC Series - Manual (Page 8)

If Hands-free is activated in NAM, you have to press
I END I to terminate a call.
To Receive Calls
1. When the telephone rings, lift the handset or press
I SEND I to answer the call. The I IN USE] indicator
will light.
2. If the handset is off the cradle when ringing starts,
press ISENDl to answer a call.
To Place a Call with a Number in the
Memory
1. Press |RCL| , then enter the memory address ( 01
through 50). The last 10 digits of the number will
appear on the readout. If the number is longer
than 10 digits, hold down the second digit of the
memory address (after pressing
|RCL| )to see the
prefix.
Note: Refer to “To Recall a Number from Memory”
and “To Review the Prefix” for more
details. ____________
2. Press I SEND I . The I IN USE j indicator will light
as the call is placed.
911 Emergency Call (NAM Option)
This feature permits you to place an emergency call
(911) even if your telephone unit has been set to the
Lock Mode or Call Restricted Mode.
Operation in Lock Mode
1. Enter the emergency call number (911); [^[Tirn
(“911” is not indicated, but the I LOCK j indicator
will light.)
2. Press I SEND I , the I IN USE] indicator will light.
3. To terminate the call, press |END| . (The | IN USE j
indicator will go out.)
Operation in Call Restriction Mode
The operation and display are the same as in the
normal mode.
Automatic Answering
With this feature, the incoming call will be automati­
cally connected for operation after two alert tones,
and the
i IN USE"| indicator will light on the readout.
Then the unit is ready for Hands-free operation.
1. To activate this mode, press IFUNCI and then
key [§ . I A.Ans j will appear on the readout.
2. This mode is deactivated when iFUNCi and then
key are pressed again.
3. This feature will not function if the unit is in the
following modes or the handset is off the cradle.
Lock, Horn Alert, and Calls in Absence Indicator.
To Mute a Phone Conversation
1. Press iFUNCj , then key . | Mute | will appear
on the readout. Then the transmit audio will be
muted and the receive audio will be heard from
the loudspeaker. You may converse privately
with a passenger during a call with the handset on
or off the cradle.
2. To return to normal conversation, press | FUNC |.
then key again or lift the handset.
3. Mute is reset when call is terminated.
Call in Progress Protection
Phone conversation will continue until call is ter­
minated, even after ignition switch is turned off.
CALL RESTRICTIONS
(NAM OPTION)
This feature permits you to impose various kinds of
restrictions on Outgoing Calls.
To Set Call Restricted Mode
Enter the three-digit security code, then press I FUNC |
, key U] then [ 7 ] .
The following key operation is needed to activate
one of the restricted modes;
rn: Only phone numbers having 11 digits or less are
accepted. Operator assisted dialing is prohibited.
: Only phone numbers having 7 digits or less are
accepted. Operator assisted dialing is prohibited.
[3l: Operator assisted dialing (0 Origination) is pro­
hibited.
[4]' No phone calls can be placed except for re­
pertory dialing from memory address 01 to 09.
However, emergency call with “911” are availa­
ble.
151 ■ No restriction.
To Exit Call Restriction
Programming Mode
Press IFUNCI , then |CLR|.
Noted): When in restricted mode 4, number storage
into the memory will not be permitted.
Note(2); In the restricted mode, a short beep tone
14 15