Audiovox SBC Series - Manual (Page 6)

BASIC OPERATION
Turning the Unit On
With the ignition switch at “ON” or “ACCESSORY”,
press IPWRI . The indicator [5 will light (all indicators
will light momentarily ; display will show your phone
number, and a tone will be heard).
• Receiving Signal Strength Indicator
The number of the shaded blocks indicates the Signal
Strength in your area. Four blocks show the maxi­
mum level. The display will vary as your car moves.
If the signal is not strong enough to place a call, the
jNO SVC] indicator will appear on the readout.
To Store a Number in Memory
then enter the phone number,
then enter the memory address (01
1. Press |CLR|
2. Press [ST^ ,
through 50).
Example: Press |STO| , key [T] then [§ , the displayed
number will be stored into memory address 15.
To Recall a Number from Memory
Press |RCL| , then enter the memory address (01
through 50).
Example: Press |RCL , key [T] then , the number
stored in memory address 15 will be displayed
on the readout.
To Review the Prefix
(Number Longer than 10 digits)
After pressing |RCL| , hold down the second digit of
the memory address.
Note; When a set of linked numbers is recalled, you
can review only the last linked number with
this feature. To review Link 1 to Link 5, use
[FUNCl , |RCL| then key [XI (X is 1 to 5). See
“Link Dialing”.
Last Number Review
Press |RCL| , key [§ then [^ again, the last number
used will be displayed.
Display Own Telephone Number
You can see your own phone number on the readout.
Press
|RCL| , key jX! then |X1 again.
Repertory Memory Scroll
This feature is useful in finding a certain phone
number by scrolling the repertory memory from one
of the designated starting addresses.
1. Press
|RCL] , key [X] then [f] .
[X] is the digit used to assign the starting address
as follows.
X Starting address
0 01
1 11
2 21
3 31
4 41
2 . Press [U or g .
[#1: Scroll upward (with roll back to 01)
(XI: Scroll downward (with roll up to 50)
Memory address and the last 7 digits of the stored
number will be displayed on the readout as fol­
lows.
Example: | 3 | 1 | - | 1 | 2 | 3 | 4 | 5 | 6 | 7 |
___________ /
Address-No. Tel. No.
Note: In this scroll feature, any vacant memory
address(es) will be skipped.
Automatic Storing into a Vacant
Memory Address
This feature allows automatic storing into a vacant
repertory memory address. This ends the possible
problem of writing over a previously stored number.
1. Enter the phone number.
2. Press ISTOl.
3. Enter a memory address group number in which
you want to store a number.
[ 0 ] : From 01 to 10
[T] : From 11 to 20
: From 21 to 30
i3]: From 31 to 40
[ 4 ] ; From 41 to 50
r#1: From 01 to 50
4. Press [#].
The memory address and the last 7 digits of the
stored phone number will be displayed on the
readout as follows.
Example: | 3 | 1 | - | 1 | 2 | 3 | 4 | 5 | 6 | 7 |
Note: If there is no vacant address in the assigned
area, the phone number will not be stored in
the memory.
10 11