Avanti W1092F - Manual (Page 7)

INSTALLATION INSTRUCTIONS
Adjusting The Leveling Legs
if the floor IS uneven adjust the legs (dc not insert pieces of wood, or any other objects under the legs).
• Loosen the leg bolt by turning it with your hand until it is at the desired height.
•Tighten the locking nut by turning it with the supplied wrench.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration occurs. (Allowable is 1 *)
Removing The Shipping Bolts
Before using the washing machine, you must remove the five shipping bolts from the back of the unit.
To remove the bolts:
• Loosen all bolts with the supplied wrench before removing them.
• Take each bolt head and pull it through the wide part of the hole. Repeat for each hole.
• Fill the holes with the supplied plastic covers.
• Keep the shipping bolts for future use.
> Connecting The Water Supply Hose
The water supply hose must be connected to the washing machine at one end and to the water
faucet at the other. Do not stretch the water supply hose. If the hose is too short and you do not
wish to move the water faucet, replace the hose with a longer, high-pressure hose.
1. Connect the cold water supply hose (Blue) fitting with the L-shaped arm to the cold water .
supply intake (Blue) on the back of the washing machine and tighten manually.
2. Connect the other, end of the cold water supply hose at the washing machine end by
loosening the fitting, rotating the hose, and retightening the fitting.
3. Connect the hot water supply hose (Red) fitting with the L-shaped arm to the hot water supply
intake (Red) on the back of the washing machine and tighten manually.
4. Connect the other end of the hot water supply hose to your sink's hot water faucet and tighten
manually.