Avanti W1092F - Manual (Page 6)

i#
Important Safety Instructions
A
WARNING
M
To reduce the risk of fire, electrical shock, or injury when
using your appiiahce, follow these basic precautkyis:
• Read all insiructjons before using the appliance. '
• DANGER or WARNING: Risk of child entrapment.
• Child entrapment anc suffocation are not problems of the past. Junked or abandoned appftances are still
dangerous... even If they will 'just sit in the garage a few days/
• Before you throw away your old appliance: Take off the door so that children may not easily dimb inside.
• Never allow children to operate, play with, or crawl inside the appliance.
• Never dean appliance parts with flammable fluids. * The fumes can create a fire hazard or explosion.
• Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may
destroy the eiectncai insulation causing an electrical shock hazard.
• During spinning, dort pot your hand in the spin basket; Because the spin basket is rotating at high speed,
rotating parts may injure your hand,
• Do not store or use gasoline or any other flammable vapors and liquids in the vkanity of this or any other
appliance. The fumes can create a fire hazard or explosion.
-Save these instaictions-
INSTALLATION INSTRUCTIONS
• 5 Plastic covers
• 1 wrench
• Instruction Manual
> Before Using Your Appliance
• RerrxDve the exterior and interior packing.
• Check to be sure you have all of the following parts:
• Hot Water Supply Hose (Red)
• Cold Water Supply Hose (Blue)
• Drain Hose (Pump)
• Hose Guide
• Clean the interior surface with lukewarm water using a soft doth.
• Allow 5 inches of space between the back and sides of the appliance.
• Put your laundry into ir.e washer evenly. Uneven laundry may cause noise or vibration.
• Dont use excessively not water (50*C or more). Plastic parts may be deformed or damaged. Also, clothing
may be deformed or bleached.
• Before washing, check aJi pockets. If nails or pins remain in pockets, they may damage the washer or Rothes.
• Never splash water on the control panel.
• Plug the washer into an exdusrve properly instaJied-grourxled wall outiet Do not under any circumstances cut
or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding
should be directed towa.": a certified elecinctan.
Selecting a Location
Before you install the wasnmg machine, select a location with the following characteristics:
• A hand level surface (if the surface is uneven, see Adjusting the leveling legs/ below.
• Away from direct sunlight. Direct sunlight may affect the acryitc coating, plastic and electrical components.
• Adequate ventilation
• Room temperature Lhai will not fall below O'C.
• Away from sources of neat sucn as coal or gas. Make sure that the washing machine does not stand on its
power cord. Ventilation ooenings .must not be. obstructed by carpeting when the washing machine is installed on
a carpeted floor.