DirecTV HAH-SA User Manual

Page 23

Using the remote control

Code Scanning

To use the Code Scanning method:

1. Repeatedly tap the top part of the

CHANNEL (CH)

button.

2. Continue to step through the codes until the component turns off, indicating

you have found the correct component code. If you accidentally pass a code
that responds or realize you may not have been aiming the remote control at
the component, tap the lower part of the

CHANNEL (CH)

button to step

backward through the codes.

3. Press the remote control

POWER

button to verify the proper code by

turning the device on and off.

4. Press the device button (in this example,

) again to lock in the code.

Changing the Remote ID

If you are using multiple satellite receivers in the same room, you may want to
change the remote control ID to avoid interference or “cross talk.” The remote
control ID can be a number from “001” to “008”.

If you change remote IDs, set your remote control to that ID number first.
Use this procedure to set the remote control to use a different remote ID:

1. From the

MAIN MENU

, highlight the

System Setup

menu tab. Press

SELECT.

2. Highlight

Remote

menu tab to access Remote Control Settings.

3. Highlight the Remote ID menu button.
4. Press and hold the remote control SAT button.
5. Press and release the

MUTE

button.

6. Release the

SAT

button. It should remain lit. If it does not, repeat steps 4-6.

7. Enter desired number (001 to 008).
8. Press the

SAT

button to lock in the code.

9. Point the remote control at the receiver. Press

SELECT.

The number to the right of the highlighted Remote ID menu button will change
to the new code. Check that the ID has been successfully set by testing the
remote control to see that it controls that satellite receiver.

Installing remote control

batteries

To install or replace the remote control batteries:

1. Locate the battery compartment on the back of the remote control.
2. Remove the battery compartment cover.
3. Insert two “AAA” size batteries as shown, observing the correct polarity.
4. Replace the battery compartment cover.