DirecTV HAH-SA User Manual
Page 11
Getting Started
3
Connect your TV
Depending on your TV, you can connect it to the receiver in one of four
ways:
• Component (Y,Pb,Pr,-HAH-SA only) video cable (best picture quality) or
• S-Video cable (excellent picture quality) or
• Video cable (very good picture quality) or
• Coaxial cable (good picture quality)
You will also want to use a pair of audio cables (L/R) to provide stereo sound.
If your TV does not have standard A/V jacks, you will hear monophonic audio.
This is acceptable for the procedures described in the next section.
To connect your TV to the DIRECTV
®
Receiver:
1. Select the appropriate connection:
If your TV has component video jacks –
• Use a component video cable (not supplied) or supplied A/V cable to
connect the DIRECTV Receiver’s
Y
,
PB
, and
PR
output to the
corresponding TV input jacks.
• Use supplied A/V cable to connect the DIRECTV Receiver’s
AUDIO
(
L
/
R
) jacks to the TV’s
AUDIO IN
jacks.
If your TV has an S-Video jack –
• Use an S-Video cable (not supplied) to connect the DIRECTV
Receiver’s
S-VIDEO
jack to the TV’s
S-VIDEO
input jack.
• Use supplied A/V cable to connect the DIRECTV Receiver’s
AUDIO
(
L
/
R
) jacks to the TV’s
AUDIO IN
jacks.
If your TV has RCA-type A/V connectors –
• Use the supplied A/V cable to connect the DIRECTV Receiver’s
AUDIO
and
VIDEO
jacks to the TV’s
A/V IN
jacks.
• If your TV has only one
AUDIO IN
jack, connect the receiver’s
AUDIO
L
jack to the TV
AUDIO IN
jack.
If your TV only has an RF (coaxial) connector –
• Connect the DIRECTV Receiver’s
OUT TO TV
connector to the TV’s
VHF/UHF IN
or
RF IN
jack.
2. Connect one end of the telephone line cord provided into the DIRECTV
Receiver’s
PHONE JACK
.
3. Connect the other end into a modular telephone outlet.
4. Plug the TV into an electrical outlet.
5. Plug the DIRECTV Receiver power cord into an electrical outlet. If the
front panel Power indicator does not illuminate, press the
POWER
button.
The data port (HAH-SA only) is used
for diagnostic and aftermarket
service. Professional installations
using the data port must utilize a
good quality shielded cable to ensure
FCC compliance.