Beko OIM 22301 X - Manual (Page 24)

Removal of oven door
1. Open the front door.
2. Open the clips at the hinge housing on
the right and left hand sides of the front
door by pressing them down as
illustrated in the figure.
1 2 3
1 Front door
2 Hinge
3 Oven
3. Move the front door to half-way.
4. Remove the front door by pulling it
upwards to release it from the right and
left hinges.
NOTICE
Steps carried out during removing
process should be performed in
reverse order (steps 4, 3, 2 and 1)
to reattach the door. Do not forget
to close the clips at the hinge
housing when reinstalling the door.
Replacing the oven lamp
DANGER
Hot surfaces may cause burns!
Make sure that the appliance is
switched off and cooled down in
order to avoid the risk of an
electrical shock.
The oven lamp is a special heat-resisting (T
300 °C) electric light bulb; see Technical
Data, page 5. Oven lamps can be obtained
from a good local electrical store.
NOTICE
Position of lamp might vary from
diagram.
1. Switch off the appliance at the mains.
2. Unscrew glass cover by turning anti­
clockwise.
3. Unscrew oven lamp by turning anti­
clockwise and replace it with new one.
4. Refit the glass cover.
24| EN