Connect Tech JB2 - Manual (Page 17)

Chapter 2: Hardware Installation 2-3
Titan/cPCI User’s Manual, ver. 0.00
Installing the Titan/cPCI Adapter in your System
To install your Titan/cPCI adapter in your computer follow these
steps:
Your Titan/cPCI adapter is very sensitive to static electricity.
Make sure you wear an anti-static wristband before you remove
the card from the anti-static shipping bag. When you remove the
board from the anti-static bag, handle it only by the edges and
place it on the anti-static bag or an anti-static mat.
1. Turn the power off to your computer.
2. Remove the Titan from its packaging, and remove the
protective rubber from the alignment pins on the Titan’s front
panel.
3. Insert your Titan/cPCI into an available 3U slot. The black
handle on the front panel should be on the bottom, in the
lowered position.
4. Push the Titan into the cPCI slot until the handle mates with
the card cage. Lift the handle to lock the Titan into place.
4. With a screwdriver, fasten the screw on the top of the panel
into the card cage for added mechanical security.