AstroStart 3106M - Manual (Page 8)

START COMMANDS
STARTING THE ENGINE
(h"r
To start the engine, press button (horn: 0, lights: 1).
The system automatically adjusts ignition duration for your type of vehicle; parking lights flash once
(duration: four seconds) then stay on all the time engine is running.
If more than one command is emitted, each successive start command resets runtime to the beginning,
parking lights flash once to confirm command has been received and horn sounds once to let you know
engine is already running.
Repeating this command will produce an audible confirmation that engine has started, which can be useful
if vehicle is not in sight.
I f engine fails to start
If your system cannot start your engine at first attempt, it will wait for a few seconds and then try again (it
could try again twice depending on reason for failure to start).
After three attempts, it will shut down automatically and wait for new command (see “Start fail Codes“ on
page 17).
U pon entering your vehicle ...
■ To prevent engine from turning off when you enter your vehicle, do not depress brake pedal or
release parking brake before having placed key in ignition and turned it to ”ON” position.
DO NOT turn ignition KEY TO “START”
position .
■ Drive as usual.
E ngine runtime
Your engine will stop automatically after a preset time (see ”Setting the runtime” on page 8). Parking lights
will stay on as long as engine is running.
T rigger input
Your remote starter is equipped with a negative trigger (pulse)
input.
This input can be connected to another remote control device
or to an AstroStart RST-2 timer output (optional).
If this input is connected, consult this device's manual or ask
your technician which command controls the Start/Stop
function.
The Start/Stop commands received on this input are ignored
while the engine is running on a remote start.
All Start/Stop functions controlled by this input behave in the
same way as functions controlled by remote.
/IstroStart