AstroStart 3106M - Manual (Page 6)

SYSTEM SET-UP
When leaving your vehicle, you should prepare it for a future remote start.
• Set heating/air-conditioning controls to desired position. (When the remote starter starts your
engine, it will also turn on your climate control system.)
• Turn your windshield wipers to the “ OFF ” position to prevent the wiper mechanism from being
damaged should the wipers be frozen or stalled under snow.
• Make sure that the remote starter has detected a valid safety sequence.
• Make sure the headlights are turned off.
• Make sure not to leave your keys in the vehicle, since some rearming functions automatically
lock the doors.
THE REMOTE CONTROL
Your remote control has been designed to fit the natural contours of your hands so that it is easier to use. It
works off three long-life lithium batteries.
It can control two vehicles separately. Up to four remote controls can be assigned to your vehicle. See
your dealer for replacement batteries or additional remote controls.
NOTE : The range of your remote control can be affected by a weak battery, interference from nearby metal
structures, hydro poles, or crowded parking lots.
USING YOUR REMOTE CONTROL
Your remote control can transmit on two different
channels, allowing control of two separate
vehicles.
Only the “Panic” command is transmitted on both
channels simultaneously.
Each command being transmitted is confirmed by
both an audible and a visual signal (LED
indicator).
CHANNEL 1:
To transmit a command
on channel 1, press
CHANNEL 2:
To transmit a command on channel 2, press desired button, then
as soon as a tone is heard or LED flashes once, release the button
for a moment then press it again and hold it down for two seconds. desired button for two
seconds.
A command will not be executed if you do not press button long enough.
Only one command will be transmitted even if a button is pressed for more than two seconds except for the
Panic button which repeats the command as long as the button is maintained.
The remote control supplied in the kit may differ from the one illustrated above.
BATTERY REPLACEMENT
Your remote works off three 3-volt lithium CR-2016 batteries or
equivalent.
We strongly recommend that you keep a replacement set in
your glove compartment.
To replace the batteries, remove screw on back of remote
case, remove old batteries and replace with new ones. Make
sure that batteries point the right way; see illustration opposite.
/istroStart