AstroStart 3106M - Manual (Page 13)

When you exit the vehicle, cycle resumes and system arms automatically (see also "TEMPORARY VALET
MODE").
If you disarm the system and do not open the door within 60 seconds, it rearms itself automatically.
The following table shows the effect that each zone has on the rearming cycle.
Protection zone Effect on rearming cycle
Hood
Doors
Additional sensor
Shock sensor
These four zones prolong rearming cycle as long as they remain in
violation.
Ignition
Activated by ignition key:
Activated by remote starter:
Cancels rearming
No effect
Warning No effect
Applying brakes or ignition key in "ON" position cancels rearming (until a door is opened, which causes
rearming cycle to restart from the beginning).
See also "TEMPORARY VALET MODE" and "DOME LIGHT DURATION".
You can disarm only with remote control by pressing t£' button (see Table of Commands on page 5).
System is disarmed immediately and restarts rearming cycle from the beginning.
TO TERMINATE ALARM CONDITION
You can terminate alarm condition by pressing rf' button, which also disarms system, or by pressing
either of the or ^ buttons, which terminates alarm condition without disarming system.
CONFIRMATION
When the alarm is armed, one chirp of the siren and/or flash of the parking lights means that all protection
zones are in normal condition and system is ready.
Three chirps or flashes means that one or more zones are in violation (e.g. at least one door is opened).
Once the zone is corrected (e.g. door closed), the system sends another confirmation (one chirp or flash if
all zones are in normal condition, three chirps or flashes if another zone is in violation).
If a zone is in violation when system is armed manually (using remote) and the cause of the violation is not
corrected, the alarm will still arm but this zone will not be able to generate an alarm condition. See also
"DOME LIGHT DURATION".
When you disarm the alarm, two chirps or flashes indicate that no one tried to break into or do anything to
your vehicle, and four chirps or flashes indicate that an alarm condition occurred during your absence.
The following table summarizes this section.
CONFIRMATION MEANING
1 chirp or flash System armed, no zone in violation.
2 chirps or flashes System disarmed, no violation detected.
3 chirps or flashes System armed with zone in violation. Indicator light indicates which zone.
4 chirps or flashes
System disarmed with violation detected.
Indicator light indicates cause of alarm condition.
/IstroStart
11