Aussie LP 7462 - Manual (Page 12)

STEP 4-BOTTQtVI SHELF/LEG & CASTER ASSEMBLY
TOOLS: (£
(ITENl 9) 4 pcs
1/4” X 1” BOLT
{ITEM 22) 1/4” X 2” BOLT 4 pcs
(ITEM 10) 8 pcs
1/4” X 1 3/8” BOLT
(DELUXE MODELS)
(ITEM 17 OR 18) AXLE
(ITEM 16) BOTTOM SHELF
(ITEM 19, 20, 21)
CASTER ASSEMBLY
•Place Leg/Side Table assemblies opposite each other as shown with the velcro patches on same side.
•Place Bottom Shelf inside of Wheel Leg assembly and align large axle holes, insert Axle through axle
holes in both sides of legs and shelf. The Axle will support this end of Bottom Shelf while
securing Fixed Leg assembly.
•For Kanga and Bonza Models, position Caster Assembly with caster wheels up and side of bracket
against Bottom Shelf. Align the Caster Bracket, Bottom Shelf, and Fixed Leg holes and
fasten using 1/4” X 2” Bolts. Attach Wheel Legs to Bottom Shelf using 1/4” x 1” Bolts. Meta! Tubing
Legs will use 1/4” x 1 3/8” Bolts. Tighten Wheel Leg bolts before proceeding.
•For Bonza Deluxe, align the Bottom Shelf and Leg holes and fasten using 1/4” x 1 3/8” bolts. Attach
Bonza Deluxe Wheel Legs the same way. Thread casters into end of leg.
•Bonza Deluxe - Important Note: When assembling Bottom Shelf on metal legs, the Axle hole in the
Bottom Shelf is not used(See Illustration below).
1/4” X 2” BOLT "WOOD
1/4” X 1 3/8” BOLT - METAL
DELUXE
^ CASTER
METAL
LEG
« *
1/4” X 1” BOLT - WOOD LEG
1/4” X 1 3/8” BOLT - METAL LEG
12