Arcam Delta 250 - Manual (Page 7)

TRACK SELECT - To begin play at a
desired track, press l< or >1 to locate
the desired track then press PLAY.
To select another track during play, press
K or >1 to locate the track. The player
will automaticaily select PLAY mode.
POWER - Switches the unit on and off.
PROG - Allows you to programme a
selection of up to 20 tracks from a disc in
any order- To programme the disc, press
track select to locate the desired track(s).
Press PROG to programme the track
tit.imber(s) into the memory. Repeat tliis
procedure to programme up to 20 tracks.
Now press PLAY. The display will
indicate the track numbers as they are
programmed. When programming the
disc by remote control, only the first
nine tracks of the disc may be selected.
REPEAT - Allows repeat play of a single
track, a programmed selection or an
entire
disc. When repeating a
programmed selection or an entire disc,
press REPEAT once before pressing
PLAY. (REPEAT will be indicated on
the display).
When repeating a single track, press
PEiPEAT twice before pressing play.
('FLEPEAT' will flash on the display).
To cancel, press REPEAT a third time
or until 'REPEAT' goes out on the
display.
TIME - Displays the elapsed time of a
track ('TRACK TIME'), the remaining
rime of a track ('REM TRACK TIME*)
or the remaining time of the disc
('TOTAL REM TIME'). The display
will indicate the time fimction selected.
DISP - Turns the display on and off.
Switching the display off will generally
give a smaL improvement in sound
quality.
FLUORESCENT DISPLAY - Infonns
you of the functions of the player. Also
houses the remote receiver. Ensure this
is not obscured or commands from the
remote control will not be received.
OPERATION BY REMOTE CONTROL
Additional functions availabie on the remote
control are;
0-9 Keypad - Allows direct access to
individual tracks on the disc. To select a
track, press the corresponding keypad
buCton(s) and then press PLAY.
The keypad can also be used when
programming a disc by remote control
(see ® PROG). Oidy the first nine
tracks of a disc may be selected.
SHUFFLE - Press to play all the tracks
on the disc in a random order.
SCAN - Plays the first 10 seconds of
each track in sequence. The track
number will be indicated on the display
while SCAN is selected. To continue
listening to a "scanned" track, press
PLAY.
VOLUME - Adjusts the volume control
of Arcam amplifiers (certain models
only).
Please Note: Certain functions on the remote
control handset may not operate this CD
player.