Arcam Delta 250 - Manual (Page 3)

INSTALLATION
© Check that your mains supply voltage
agrees with the voltage setting indicated
on the rear panel of the unit,
if your mains supply voltage is different,
consult your Arcam dealer.
MAINS SAFETY
This product is normally supplied \vith
a moulded mains plug already fitted to
the lead. If for any reason the plug
needs to be removed, it must be
disposed
of immediately and
securely, as it is a potential shock
hazard when inserted into a mains
socket.
If the plug is removed then the
remaining lead must be rewired as
follows:
The blue wire must be connected to
the terminal which is coloured blue or
marked with the letter N.
The brown wire must be connected to
the terminal which is coloured brown
or marked with the letter L.
The green and yellow wire must be
connected to the temiinal which is
coloured green and yellow, or
marked with the letter E or the safety
earth symbol.
When replacing the fuse in the supplied
moulded mains plug, the integral fuse
holder/cover must always be refitted.
Warning;
earthed.
This apparatus must be
MAINS SUPPLY CONNECTIONS
Insert the EEC line socket of the mains
lead fully into the power inlet socket on
the rear panel. Connect the other end
to your mains supply.
• For optimum sonic performance, the
analogue power supply of the CD
player is kept powered up all the time
the unit is connected to the mains
supply. The firont panel power switch
powers down all other circuitry leaving
the analogue sections in "standby".
This means that even chough the power
switch is off, it may be possible to hear
a slight residual hum emanating from
the mains transformer inside the CD
player. This is perfecdy normal. Tithe
unit is to be left unused for an extended
period, we recommend that it is
disconnected fi-om the maans supply by
switching it off at the wall socket.
DELTA 270 ONLY
DIGITAL AND AUDIO CONNECTIONS
DIGITAL OUTPUTS - For use with a
separate digital to analogue converter
(DAC) or digital recorder. Connect to
the unit’s digital input using a suitable
digital cable. Both outputs are identical
and can be connected simultaneously if
necessary.
© AUDIO OUTPUT - Connect to your
amplifier's CD or AUX input using a
suitable interconnect cable.
Insert the red phono plugs into the
sockets labelled 'R,' and the other plugs
into the sockets bbelled ’L'.