Beko MF 5 - Manual (Page 13)

Cleaning and care
Before cleaning always switch your cooker
off at the socket outlet and pull out the plug.
Warning!
* Make sure that the oven, grill and steam
vent are cool before you start cleaning.
* Do not immerse your cooker in water.
Use a damp cloth to clean the interior and
exterior. Never use any sharp instruments,
abrasive household cleaner, or detergents
for cleaning. For hard stains use suitable
washing liquid.
We recommend that grill elements be wiped
with a damp cloth to remove any fat
splashes. This will prevent fumes for any
fat being burnt off when the cooker is next
used. Again before cleaning ensure the grill
elements are cool.
It is recommended that the acidic matters
such as oil, lemon etc. should be cleaned
immediately.
Note: Even though grease and other foodstuff
may leave marks on hobs when baked on.
they will not affect the performance of the
appliance under normal conditions.
Cleaning Interior of your oven
Before switching on again ensure that all
controls are in the OFF position. Take out
all trays and the grill out of the oven. Clean
out the interior with a piece of moist, soapy
cloth. Then, clean it once more with a wet
piece of cloth and let it to dry.
Do not use dry powder agents for cleaning.
Special cleaners that are commercially
available may be used after carefully reading
the warning that are written on the labels.
Never clean the inside of the oven and trays
by using materials such as hard brushes,
steel pads or knives.
Do not use cleaning agents containing acid
or chlorine on stainless steel surfaces and
the handle. Cleaning can be accomplished
using a soft piece of cloth wetted with soapy
water or with commercially available special
surface cleaners and a soft piece of cloth.
11
If you want to remove
and clean “the plastic
cover”
Release the plastic protection
cover by fitting it between the
front door and protection, near
to the notches, with your hand
or something like a straight
instrument (e.g. head of a spoon). Later on, release it, and also
remove from the top notches, and take it out. Clean the plastic
protection cover only with liquid type cleaners. Never use hard
materials while locating the protection to its place, first locate
it to the upper notches, then fit it to the bottom notches. Control
whether it is fit to the notches by opening the door and looking
from the glass.