Inputs, Outputs, Total harmonic distortion – Arcam SA200 User Manual
Page 13: Frequency response, Power requirements, Dimensions (overall), Weight, Sa200 technical specification
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SA200 Technical Specification
Inputs
Fixed level inputs are connected to pin 3 (LEFT) and pin 5 (RIGHT) of a 5 pin 180° DIN socket
and/or two phono sockets located in the rear sub panel. This sub panel is removable to allow
other types of connector to be substituted, if required.
Sensitivity
Gain to loudspeaker terminals
Signal/noise ratio
Input impedance
l.OOV (ref. lOOW
/8 ohms, 1 kHz)
29.0 dB at 1 kHz, non-inverting
> 100 dB. unweighted or CCIR/ARM
weighted, (ref. 100W/8ohms)
20ki>
Outputs
Loudspeaker outputs are via red and black heavy duty screw terminals. These will accept bare
wires or 4mm (‘Banana’) plugs. Suitable for 4-16 ohm loudspeakers.
The continuous power output, both channels driven (at 0.08% t.h.d., 20 Hz-20 kHz), exceeds
lOOW/channel into 8 ohms
160W,/channel into 4 ohms
The typical maximum power output at 1 kHz. at clipping (0.1% t.h.d.), both channels driven is
125W/channel into
8 ohms
195W/channcl into 4 ohms
Total Harmonic Distortion
At any level up to lOOW
/8 ohms. 1 kHz < 0.03% (typ. 0.01%)
At any level up to 160W/4 ohms, 1 kHz < 0.05% (typ. 0.02%)
Frequency Response
-I- 0, - 0.5 dB 10 Hz-20 kHz. It is recommended that the pre-amplifier’s high frequency response
should be curtailed to at least - 3 dB at 50 kHz.
Power Requirements
240 VAC. 48-63 Hz, 600 VA maximum. The unit may be dealer adjusted to work at 220V or
120V if required.
Dimensions (overall)
Width 464mm (I
8V4")
Height 95mm (
3^4")
Depth 350rnm (13%")
Weight
Net 10.0 kg (22 lb)
Packed 14.0 kg (31 lb)