Inputs, Outputs, Total harmonic distortion – Arcam SA200 User Manual
Page 12: Frequency response, Power requirements, Dimensions (overall), Weight, Sa150 technical specification
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SA150 Technical Specification
Inputs
Fixed level inputs are connected to pin 3 (LEFT) and pin 5 (RIGHT) of a 5 pin 180° DIN socket
and/or two phono sockets located in the rear sub panel. This sub panel is removable to allow
other types of connector to be substituted, if required.
Sensitivity
Gain to loudspeaker terminals
Signal/noise ratio
Input impedance
0.87V (ref. 75W/8ohms. 1 kHz)
29.0 dB at 1 kHz, non-inverting
> 100 dB, unweighted or CCIR/ARM
weighted, (ref. 75W/8 ohms)
20 kQ
Outputs
Loudspeaker outputs are via red and black heavy duty screw terminals. These will accept bare
wires or 4mm (‘Banana’) plugs. Suitable for 4-16 ohm loudspeakers.
The continuous power output, both channels driven (at 0.08% t.h.d., 20 Hz-20 kHz), exceeds
75W/channel into
8 ohms
1 low/channel into 4 ohms
The typical maximum power output at 1 kHz, at clipping (0.1% t.h.d.), both channels driven is
90W/channel into
8 ohms
125W/channel into 4 ohms
Total Harmonic Distortion
At any level up to 75W/8 ohms, 1 kHz > 0.03% (typ. 0.01%)
At any level up to llOW/4 ohms, 1 kHz > 0.05% (typ. 0.02%)
Frequency Response
-I- 0. - 0.5 dB 10 Hz-20 kHz, It is recommended that the pre-amplifier’s high frequency response
should be curtailed to at least — 3 dB at 50 kHz.
Power Requirements
240VAC, 48-63 Hz, 500VA maximum. The unit may be dealer adjusted to work at 220V or
120V if required.
Dimensions (overall)
Width 464mm (I
8V4")
Height 95mm (
3^/4")
Depth 350mm (13^4”)
Weight
Net 9 kg (20 lb)
Packed 13 kg (29 lb)