Bolens 111-518R000 - Manual (Page 7)

FIGURE 7.—Optional Hub Caps
5. Thread axle bolt into rear hole of pivot bar. Tighten
securely.
6. Assemble other rear wheel in the same manner.
INSTALLATION OF HUB CAPS (Optional)
1. If your mower is equipped with hub caps which
have four tabs, line up the tabs on the hub caps
with the holes in the wheels. Push to lock in
position.
2. If your mower is equipped with 2" wide tires, place
hub caps in position against the inner hub of the
wheel. Press firmly around the center portion of
hub cap in a circular motion, similar to installing
-------a lid on a round, plastic container. See figure 7.
The hub caps are flexible and will snap over the
31 / 2 " diameter wheel hubs.
NOTE: It may be helpful to place the hub caps In hot
tap water for several minutes to make them pliable
before installing, especially if the temperature is less
than 60° F.
FINAL ASSEMBLY OF MOWER
Make certain all nuts and bolts are tightened securely.
ASSEMBLY OF GRASS CATCHER (Hardware F)
NOTE: Make certain the grass bag is turned right side
out before assembling (warning label will be on the
outside).
1
.
There are three holes in the rear frame. With the
■holes on the upper side as shown in figure 8A, in­
sert one end of the rear frame into the cloth chan­
nel on the edge of the grass catcher bag. Feed all
the material on one side of the frame, then work
it around the frame. See figure 8B.
FIGURE 8.
2. Slide the ends of the front frame assembly into the
—ends of the rear frame as shown in figure 9A.
3. Secure front of bag to front frame by slipping
plastic channels on sides and bottom of bag over
frame. See figure 9B.