Black & Decker TRIMCAT 2832 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

This is a normal condition, and does not indicate a problem.
3.
(98020 ONLY)
This charger has an internal temperature limit that, when
exceeded, will temporarily stop the full charge current. This is indicated
by the yellow light being ON. The normal charge cycle will resume when
the temperature falls below the preset limit and will be indicated by the
yellow light turning OFF. The charge time may be extended beyond the
normal 15 minutes. Use the charger in normal room temperatures when
ever possible. To prevent overheating, do not cover the charger and do
not charge battery packs in direct sunlight or near heat sources.
4.
If the battery pack does not charge properly — (1) Check current at
receptacle by plugging in a lamp or other appliance, (2) Check to see if
receptacle is connected to a light switch which turns power off when you
turn out the lights. (3) Move charger and battery pack to a location where
the surrounding air temperature is approximately 65°F - 75°F (18°-
24°C). (4) If charging problems persist, take or send the tool, battery pack
and charger to your local service center.
5. The battery pack should be recharged when it fails to produce sufficient
power on jobs which were easily done previously. DO NOT CONTINUE to
use under these conditions. Follow the charging procedure. You may also
charge a partially used pack whenever you desire with no adverse affect
on the battery pack.
6. Under certain conditions, with the charger plugged in to the power sup
ply, the exposed charging contacts inside the charger can be shorted by
foreign material. Foreign materials of a conductive nature such as, but not
limited to, steel wool, aluminum foil, or any buildup of metallic particles
should be kept away from charger cavities. Always unplug the charger
from the power supply when there is no battery pack in the cavity. Unplug
charger before attempting to clean.
7. Do not freeze or immerse charger in water or any other liquid.
8.
WARNING:
Don't allow any liquid to get inside charger. Electric shock
Figure 3
BLADE CLAMPING
SCREW
WRENCH
INNER CLAMP
WASHER
OUTER CLAMP
WASHER
Figure 4
lock
BUTTON
BEVEL ADJUST
MENT KNOB
Figure 5
LOOSEN
CLOCKWISE
TIGHTEN
COUNTERCLOCKWISE