Bolens 522 - Manual (Page 6)

FIGURE 3.
4. Place one flat washer just removed on each axle.
Secure with hex slotted nut. Tighten siotted nut
until snug, then back off approximately 1/3 turn or
until one of the slots on the slotted nut lines up
with the hole in the axle.
5. Insert cotter pins through slots in nuts and holes in
axle. Secure by bending the ends of the cotter
pins in opposite directions, using pliers and a
screwdriver.
6. Check the assembly of the wheels. There should
be no side to side play, and the wheels should
spin freely.
7. Place hub caps in position on wheels, and tap on
with a soft hammer or mallet. (It may be neces­
sary to use a screwdriver to tap on the raised rib
of the hub cap.)
8. Check tires for correct air pressure. Correct tire
pressure is between 12-15 lbs.
AHACHING TONGUE TO RESERVOIR TANK
1. The tongue is shipped with the jack stand already
attached to the tongue. The jack stand is in the
transport position. Remove the spring pin and
clevis pin. Pivot the jack stand to the operating
position (90°), and secure with the clevis pin and
spring pin. See figure 3.
2. Remove the two hex bolts, lock washers and hex
nuts on the front of the reservoir tank. Two 9/16"
wrenches are required. Place the tongue in
position with jack stand facing down, and secure
with hardware just removed. Remove the assem­
bly from the blocks. See figure 4.
FIGURE 4.
ATTACHING THE BEAM SUPPORT/
LATCH BRACKET
1. Remove the two hex bolts, lock washers and hex
nuts from the tongue, using two 9/16" wrenches.
2. Place the beam support/latch bracket on the
tongue as shown in figure 5. Secure with hex
bolts, lock washers and hex nuts just removed.
Tighten securely.