Avanti 1292YWT - Manual (Page 11)

Changing the Direction of Opening the Door
if you find the direction of opening the door on your appliance inconvenient,
you can change it. Holes on the opposite side have already been prepared
in the factory and are now plugged.
• Remove the cover on the upper hinge, unscrew the hinge and take off the
freezer door (the door is not fixed on the middle hinge), don’t forget to
remove the washer from the middle hinge.
• Unscrew the lower hinge with foot and washer and remove the refrigerator
door.
• Unscrew the middle hinge and the other foot.
• Fix the lower hinge with foot (and washer) to the opposite side and fix the
other foot on the place where previously was the hinge.
• Remove the fastener of the door corner with the hole and replace it to the
opposite side.
• Put the refrigerator door on the lower hinge.
■ Rotate the middle hinge for 180“, replace it to the opposite side of the door
and fix it.
Put on the washer first and then the upper door.
• Fix the upper hinge and cover it.
• Unscrew the handles and replace them to the opposite side (not for
handles mouinted horizontally).
Some screws are covered with caps. Take them off before undoing the
screws.
• Plug the remaining holes with decorative caps.
• Check the gasket, it shouldn’t be creased and it should seal well.
12 Instructions for Use