Aiwa ICT-X40B - Manual (Page 10)

TAPE PLAYBACK
SOUND ADJUSTMENTS
Auto reverse function
When the end of the tape is reached during
playback or fast tape transport, the direction of
the tape is automatically reversed, and playback
starts again.
Tape direction indications
1 2
Playback Fast- forward
or rewind
Upper side
Lower side
O'O
Before turning the ignition off
Be sure to eject any cassette from the unit before
turning the ignition off. Otherwise, the unit may be
damaged when you detach the front panel.
Switching modes
When the unit is in Radio mode, inserting a
cassette switches the unit to Tape Play mode
automatically.
To prevent tape problems
Before inserting a cassette into the unit, make
sure that there is no slack in the tape. If necessary,
take up the slack by inserting a pencil into the
spindle hole and winding.
90-minute or longer tapes are extremely thin and
easily deformed or damaged. They are no
recommended.
Press SEL to select the mode that you
wishtoadjustfrom: VOL (volume), BAS
(bass), TRE (treble), BAL (balance) and
FAD (fader).
The following indications appear in cyclic
order.
c
iHJL-*llFI
5-i
Re-*IIRL'*F FI I
3
The selected mode switches to volume mode
if you do not proceed with step 2 within 5
seconds.
Press +/— to adjust the level.
Press and hold either button to change the
level rapidly.
Adjust each mode referring to the audio
control indicators in the display window, (see
page 3)
-
+
IJOL
Decreases the
volume level
Increases the
volume level
11 FIS
Decreases the
bass level
Increases the
bass level
IRE
Decreases the
treble level
Increases the
treble level
sni.
Decreases the
level of the right
speaker(s)
Decreases the
level of the left
speaker(s)
F F I I I
Decreases the
level of the front
speakers
Decreases the
level of the rear
speakers
Without selecting any mode with SEL, only
the volume level can be adjusted by pressing
+/-.
9
ENGLISH