Installation – Atech Flash Technology PRO-GEAR XM-4U User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation
[10
Therefore, we shall have:
Set 1 USB wires
Red wire goes to pin 1
White wire goes to pin 2
Green wire goes to pin 3
and
Set 2 USB wires
Red wire goes to pin 6
White wire goes to pin 7
Green wire goes to pin 8
Comparing the default wire setting on the Internal USB
cable, no wire reassignment is necessary. We can plug in
the black pin connector of Internal USB cable to the USB
header directly, with red wire goes to pin 1 or 6.
Please note that your motherboard USB header pin
assignment could be different from the example above. If you
need to reassign wires on Internal USB cable, please follow
the procedure below: