AEG LAVMAT BELLA 1003/803 - Manual (Page 14)

The programme switch stops during the
programme cycie.
Your fully automatic machine has been
fitted with the Thermo-Chron control
system. This means that the control knob
stops during prewash and main wash
until the required temperature is reached.
The washing powder foams excessiveiy.
Too much washing powder or the wrong
powder has been used. Omit the prewash
from your next programme or reduce the
amount of washing powder used. Use a
low lather powder.
The programme (white or coioureds) has
been compieted without spinning.
The thermal protection device of the
motor has tripped. Possible causes:
blocked drain filter, kinked drain hose.
The spinning cycle will automatically co­
me on again after a certain period has
elapsed (up to an hour).
The door cannot be opened immediately
on completion of the programme cycle.
Please wait until the release time of the
door locking mechanism has elapsed
(about 1 minute).
Should you be unable to locate the cause
of a problem in s^ i of the above check
list, then please coTitact your AEG Service
Department. To assist our service staff,
please quote the E-number of your ma­
chine which you find on the inside front
cover of this booklet or on the rating plate
of your machine.
If you call a service engineer in connec­
tion with one of the aforementioned pro­
blems, please note that the cost involved
will have to be passed on even during the
warranty period.
A more comprehensive guaran' is
offered by our AEG Service Club. ■ or a
modest annual premium you can sign a
service agreement with our Tec’ cal
Service to cover your machine.
14