AEG LAVMAT BELLA 1003/803 - Manual (Page 12)

Operating procedure
Washing
Plug the machine In or switch on (If per-
manently connected).
Hook the drain hose over sink edge.
Uniess piumbed in, connect the suppiy
hose to the tap.
Open the tap.
Open the door.
Load with dry iaundry.
Ciose inner and outer doors.
Please ensure that both doors àr« closed
properly as otherwise the programme
cannot start. The outer door must engage.
Puli out the drawer type washing powder
dispenser.
Add washing powder.
Push the dispenser back in.
Select the required temperature.
Rotating the programme selector in
clockwise direction, set it to the required
position.
Press buttons as necessary ( tH/ ,
, \W 2 y or E).
Press button [T]
The programme starts.
The left control lamp lights up.
The programme selector begins to rotate.
It stops during heating-up until the re­
quired temperature is reached.
Opening of the outer door during opera­
tion will immediately interrupt the pro­
gramme.
It Is not possible to open the door during
spinning (safety feature).
Please remember that the glass of the
door gets hot during washing (do not
touch). The door features a safety lock
and cannot be opened during a pro­
gramme cycle.
On completion of the programme
the machine switches off automatically
12
ana me programrne seleoior temams in
the relevant cut-< oosition (one of the
breaks in the cycle indicator band).
Press button
The control light goes out.
Return the temperature control to ”0”.
If the programme ends with the laundry in
the last rinse water, remember to pump
off the water before opening the door.
Open the door (on programmes with
spinning cycle this is not possible until
approx. 1 minute after completion of the
programme — safety feature.)
Remove the iaundry.
if you have nothing else to wash, retóse
the tap, pull the plug out of the so. or
switch off.
Maintenance
When you have done all your wa ig,
close the tap and pull the plug out or the
socket or switch off the main switch.
Leave the door open for a short while to
allow the machine to dry out. Remove any
washing powder left in the dispenser. To
do this, hold the dispenser with both
hands, lift and pull out completely, giving
it a short sharp pull.