ADT Security Services 6112 - Manual (Page 8)

Reset Command Center Sounders
Reset Alarm Memory Display
COMMAND 4 performs two functions for your security system.
Use this command to silence your Command Center sounder
during service alert, and to reset the Command Center alarm
memory.
COMMAND
To use COMMAND 4:
1. Ensure that your security system is disarmed.
2. Press the COMMAND bar. The Command Mode
indicator light comes on.
3. Press the j|i| key. The Command Center sounder is
silenced, and any flashing Zone Status indicator lights are
turned off if the zone is normal.
13
Transmit Test Report
O I have this feature,
d I do not have this feature.
Testing the communication link between your security system
and the Central Station is an important part of maintaining a
high level of security for your property. The Command Center
minimizes the time and trouble of testing by allowing you to
send a special test signal by pressing three keys. Arming the
system is not necessary, however you should always call the
Central Station before transmitting a test report.
COMMAND 1
To use COMMAND 4 1:
1. Ensure that your security system is disarmed.
2. Press the
I
COMMAND
I
bar. The Command Mode
indicator light comes on.
3. Press the |||| key, and then press the ||jij key.
4. After the report is received at the Central Station, the
Command Center will emit a beep tone for two seconds.
This is to confirm that the test signal was properly
transmitted and received.
14