Ez-30/10 transmitter code learning, Code, 3 flashes for the 3 – Crimestopper Security Products EZ-30 User Manual

Page 16

EZ-30/10 TRANSMITTER CODE LEARNING

Transmitter Code Learning:
Notes: Remote Transmitters come pre-programmed from the Factory. When re-learning remotes or adding remotes,
ALL your system’s remote codes must be learned at time of programming!! These systems allow storage of up to 4
different remote codes in memory. Antenna / Receiver must be plugged into unit.

1. Open hood (ground the Gray hood pin wire if no hood pin is installed.)
2. Turn key to the ON position. (Do not start vehicle)
3. Press Program/Valet button 4 times. After a few seconds, the unit will flash the parking lights 4 times.
4. EZ-30: Press Button #1 (Lock) of the transmitter to be learned. EZ-10 Model: Press Engine Start button. You should

get 2 light flashes indicating the code-learn. Now the unit is waiting for a 2

code, so repeat this step as needed with

up to 3 additional remotes. The unit will flash the lights in succession after each code learned for up to 4 codes. (2
flashes for the 2

code, 3 flashes for the 3

code etc.) If all 4 codes are learned, the unit will automatically exit code

learning mode, otherwise turn key OFF and close the hood. (See Diagram Below)

IGN

OFF

WAIT FOR

4 FLASHES

PRESS 4X's

FLASH 2, 3, or 4 X's

(GRAY WIRE GROUNDED)

EZ-30

IGN

OFF

PRESS

LOCK BUTTON

EZ-10

COMPLETE

START BUTTON