Crimestopper Security Products CS-2016FM User Manual
Cs-2016fm the informer ii, Operation instructions, Introduction
CS-2016FM The Informer II™
2-Way FM Paging Alarm & Remote Engine Starting System
OPERATION INSTRUCTIONS
INTRODUCTION
CONGRATULATIONS on your choice of the Informer II™ by Crimestopper Security Products Inc. This booklet
contains the information necessary for operating your system. If any questions arise, contact your installation dealer or
Crimestopper Security Products Inc.
*IMPORTANT INFORMATION: Primary and Optional Features
-PRIMARY: These are features that must be connected in order for the system to operate properly i.e. Power,
Ground, LED, etc.
-OPTIONAL: Optional features are connected only if desired or agreed upon by the installing dealer i.e. Horn Honk,
Dome light illumination, Door Locks, Trunk Pop, etc. These features may require additional parts and labor charges.
Consult with your installer about these features BEFORE installation!
CONTACT INFORMATION:
This device complies with FCC Rules part 15. Operation is subject
to the following two conditions: 1) This device may not cause
interference, and (2) this device must accept any interference that
may be received, including interference that may cause undesired
operation. The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modification to this
equipment. Such modification could void the user's authority to
operate the equipment.
TECHNICAL SUPPORT (800)-998-6880
Monday - Friday 8:00am - 4:30pm Pacific
Website: www.crimestopper.com
E-mail: [email protected]
CRIMESTOPPER
SECURITY PRODUCTS, INC.
1770 S. TAPO STREET
SIMI VALLEY, CA. 93063
REV. B 09.2004
Document Outline
- CS-2016FM The Informer II™
- 2-Way FM Paging Alarm & Remote Engine Starting System
- OPERATION INSTRUCTIONS
- Selective Shock Sensor Disable
- UNSUCCESSFUL REMOTE START
- REMOTE OPERATED CARJACK PROTECTION
- SWITCH-CONTROLLED & FULL TIME CARJACK (PINK WIRE CONFIGURATION)
- 2 VEHICLE CONTROL
- TROUBLESHOOTING FAQ’s: “BEFORE YOU CALL SECTION”
- Your CS-2016FM system uses FM High-Frequency signals to send/receive data between the pager and the vehicle and from the vehicle to the remote for state-of-the-art operation.
- Under normal operation, the distance from the vehicle-paging-the-remote will be greater than that from the remote-to-the-vehicle. This is due to power supplies. The main control module (brain) in the vehicle is connected to the electrical wiring rece
- TROUBLESHOOTING continued
- TROUBLESHOOTING FAQ’s: “BEFORE YOU CALL SECTION”