Garmin eTrex Legend Cx - Manual (Page 12)

2 eTrex Venture Cx and Legend Cx Owner’s Manual
G
ETTING
S
TARTED
> U
NIT
O
VERVIEW
Installing the Batteries
The eTrex operates on two AA batteries (not
included), which are installed in the back of the unit.
You can use Alkaline or NiMH batteries. See page 57
for information on setting the battery type.
To install the batteries:
1. Remove the battery
cover by turning the D-Ring
1/4 turn counter-clockwise
and pulling the cover loose.
2. Insert the batteries,
observing the proper
polarity. A polarity diagram
is molded into the battery
compartment.
3. Reinstall the battery
cover by aligning the back
cover with the unit and
turning the D-Ring 1/4 turn
clockwise.
Remove the batteries from your eTrex when you do
not expect to use the unit for several months. Stored
data is not lost when batteries are removed.
To install the lanyard:
1. Place the loop of the lanyard through the slot
at the upper-left side on the back of the unit.
2 Route the strap through the loop, and pull tight.
Battery
compartment
Locking
pin slot
Belt Clip
(attaches to belt
or waistband)
Lanyard installation
Belt Clip Knob
(attaches to back of
unit)
Auxiliary Mount Adapter
(Do not discard. This adapter
attaches to the unit for
connection to mounting kits.)
PUSH
TO EJECT