beautypg.com

Throttle control, Recoil starter, Operation – MTD 113-120A User Manual

Page 8: Keep hands and feet awf ly, Note, Before starting, To start engine and engage blade, Recoil starter handle, Figure 14, To stop engine and blade

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

THROTTLE CONTROL

The throttle control is located on the right :>ide of

the upper handle. It is used to regulate the (jngine
speed. The engine should be started with the
engine in the FAST or START position.

^ WARNING

\

The throttle control cannot be used
to stop the engine.

RECOIL STARTER

The recoil starter handle is attached to the f andle.

See figure 12. Stand behind the unit in the
operating position to start the unit.

OPERATION

Caution ^

I

Do Not O p e r a t e M o w e r U n l e s s I T

G u a r d O r E n t i r e G r a s s c a t c h e r j l s
I t s P r o p e r P l a c e .

|

KEEP HANDS and FEET AWf lY

DANGER

m

FIGURE 13.

Keep hands and feet away from the chute irea on

cutting deck. See figure 13.

NOTE

The wheels are set in a low cul-
ting height position for shipping

purposes. For best results, raise thu
cutting position until it is detei-
mined which height is best for your
lawn. See cutting height adjustmen .

BEFORE STARTING

1. Service engine with oil and gasoline as in­

structed

in

the

separate

engine

nanual

packed with your unit. Read the instructions

carefully.

2. Attach spark plug wire to spark plug.

TO START ENGINE AND ENGAGE BLADE

1. Move the throttle control lever to FAST or

START position.

2. Standing behind the unit, depress the blade

control handle and hold it against the upper

handle as shown in figure 14.

3. Grasp the recoil starter handle as shown and

pull up rapidly. Return it slowly to the rope
guide bolt.

4. After engine starts, move throttle control lever

to desired engine speed.

imim

Blade

Blade

Control

Handle

Recoil Starter

Handle

FIGURE 14.

TO STOP ENGINE AND BLADE

1. Release the blade control handle to stop the

engine and blade.

t

WARNING j

The blade continues to rotate for a

few seconds after the engine is shut
off.

2. Disconnect the spark plug wire and ground it

against the engine to prevent accidental start­

ing while equipment is unattended.

USING YOUR ROTARY MOWER

Be sure that lawn is clear of stones, sticks, wire,

or other objects which could damage lawn mower
or engine. Such objects could be accidently
thrown by the mower in any direction and cause

serious personal injury to the operator and others.

Operate a new engine at intermediate speeds and
light load for the first few hours as you would a

new automotive engine.

This manual is related to the following products: