beautypg.com

Off season storage, Handle storage, Off-season storage – MTD 113-120A User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

as it will invite rust and corrosion and may cause
an uneven discharge of grass clippings at the next
cutting.

The deck may be cleaned by tilting the mower for­
ward or on its side and scraping clean with a

suitable tool or by washing with a stream of water

from a garden hose.

A

CAUTION

Do not direct the stream of water at

a hot engine as damage to the
engine may result.

ENGINE

Refer to the separate engine manual for engine
maintenance instructions.

AIR CLEANER

Service air cleaner every 25 hours under normal
conditions. Clean every few hours under extreme­
ly dusty conditions. Poor engine performance and

flooding usually indicates that the air cleaner

should be serviced.

To service the air cleaner, refer to the separate

engine manual packed with your unit.

SPARK PLUG

The spark plug should be cleaned and the gap

reset once a season. Spark plug replacement is
recommended at the start of each mowing
season; check engine manual for correct plug
type and gap specifications.

OFF SEASON STORAGE

The following steps should be taken to prepare

lawn mower for storage.

1. Clean and lubricate mower thoroughly as

described in the lubrication instructions.

2. Refer to engine manual for correct engine

storage instructions.

3. Coat mower’s cutting blade with chassis

grease to prevent rusting.

4. Store mower in a dry, clean area.

HANDLE STORAGE

The handle may be placed in an upright position

for storage. Move hairpin cotters to outer hole on
weld pins. See figure 2. Press inward on the bot­
tom of the lower handle and push forward. The

handle will lock in this position.

To place the handle in the operating position,

remove the starter rope from the rope guide bolt.
Grasp the lower handle at the bottom, pull inward
slightly and tip the handle backward. Place the
cotter hairpins in the inner holes. With the spark
plug wire disconnected and grounded, depress

the blade control handle and pull the starter rope
out from the engine. Slip the starter rope into the
rope guide bolt.

NOTE

The use of any accessory on this Rotary Mower

other than those manufactured by the mower
manufacturer is not recommended.

GRASS CATCHER Model G03 is available as optional equipment for the

mower shown in this manual.

t WARNING {

1. DO NOT operate the mower without the entire grass catcher or chute

deflector in place.

2. DO NOT operate the mower without the protective shield on the rear

of the deck in place.

NOTE

Under normal usage bag material is subject to wear and should be

checked periodically. Be sure any replacement bao '"' nplies with the
mower manufacturer’s recommendations.

For replacement bags, use only factory authorized replacement bag No.

764-0176.

11

This manual is related to the following products: