Note, Figure 4 – MTD 113-120A User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Brake
Cable
Flange on
Plastic Fi
Slot
Hole
on Bottom of
Housing
3. Place the end of the brake cable into the up
per hole on the bottom of the throttle control
housing, and through the slot as shown in
— figure 4. The angle of the flange on the plastic
fitting must be positioned as shown in the il
lustration. Be careful not to bend or kink the
cable.
NOTE
The control cable should be as
sembled under the lower handle.
FIGURE 4.
Blade
Control
Handle
“Z” End
Brake Cable
Snap the end of the cable into the throttle con
trol housing. Hook the “Z” end of the brake
-cable into blade control handle. See figure 5.
FIGURE 5.
End of
Brake
Cable
NOTE
It may be necessary to push the end
of the brake cable using a screw-
■driver as shown in figure 6 to ailow
enough slack for the cable to be as
sembled to the blade control handle.
FIGURE 6.