Throttle control assembly, Clutch control rod installation – MTD 214-381-000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THROTTLE CONTROL ASSEMBLY
Assemble the throttle control to the handle panel
as follows.
, 1. Hold the throttle control assembly beneath
the handle panel. Turn the control sideways
and insert the lever up through the wide por
tion of the siot on the handle panel. See figure
------ 7A.
After the end of the lever is through the slot,
turn and then tip the control forward as shown
-in figure 7B to slide it through the slot.
NOTE
The lever must be all the way to the
back of the control housing as
shown in figure 7B.
3. Push the control back into the slot in the han
dle panel and press in place. Be certain the
—control is locked securely into the slot.
4. Secure throttle control cable to handle with
cable ties (C). Cut off excess ends.
FIGURE 7.
K - Hairpin
Cotter (I)
CLUTCH CONTROL ROD INSTALLATION
1. Place shift lever (located on handle panel) in
neutral (N) position, Piace bent end of control
rod into shift lever. Secure with hairpin cotter
----- (I). See figure 8.
2. Thread ferrule (H) onto the other end of con
trol rod so that the ferrule lines up with the
hole in idler bracket. Secure with hairpin cot
ter (I). See figure 8.
FIGURE 8.