Depth bar installation, Handle assembly, Note – MTD 214-381-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Depth Bar
Spring
Pin (L)
DEPTH BAR iNSTALLATiON
Slide the depth bar into the tailpiece to desired
depth. Secure with clevis pin (K) and spring pin (L).
■See figure 4.
FIGURE 4.
HANDLE ASSEMBLY
1. Secure handle panel to handles by placing
carriage bolts (M) through the lower holes in
the handle panel and through the handles.
Secure with lock washers (N) and hex nuts (O),
finger tight only.
2. Remove hex bolt and belleville washer from
----- each side of frame as shown in figure 5.
FIGURE 5.
Hex Bolt (D)
3. Place the handle panel assembly in position
against the frame.
4. Start the hex bolt and belleville washer (re
moved in step 1) by hand in the bottom hole in
handle. See figure 6.
5. Select height position for the handle by lining
up one of the holes in the handle with desired
hole in frame. See figure 5.
6. Place belleville washer (E) on hex bolt (D), and
insert hex bolt through handle and frame.
Secure with lock washer (F) and hex nut (G) on
inside of frame. See figure 6.
7. Tighten all nuts and bolts securely.
FIGURE 6.
NOTE
The clutch rod must be readjusted
whenever the handle height is
changed.