Throttle assembly, For panel mount control, To adjust – MTD 217-300 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
THROTTLE ASSEMBLY
FOR PANEL MOUNT CONTROL
To assemble the Throttle Assembly, push the black plastic knob in all the way, then pull it out until the detent
ball clicks into the second notch. If the Throttle Assembly does not do this see adjustments below. The knob
will be pulled out approximately 1-3/8” when in the second notch. In this position the spring lockwasher and the
hex nut will slide past the detent ball. Place the conduit through the slot in the handle panel (see fig. 2) and
push the unit (see fig. 3) in until it seats as shown (see fig. 1). Secure with the spring lockwasher and hex nut.
HANDLE PANEL
then make good contact with stop
switch to short out ignition.
To Adjust;
Place Throttle on equipment in FAST
(high speed) position. Lever "C” on
carburetor should be just touching
choke arm at “D”. To adjust, loosen
casing clamp screw “A” on blower
housing. Move control casing “B”
forward or backward until correct
position is obtained. Tighten screw
“A”. Recheck above operation and
replace Air Cleaner.
FORM NO. 770-912H
PRINTED IN U.S.A.