Generac Power Systems MC - Manual (Page 80)

3.3«3>lO-TnsLa11 tappets*
3*3*3*12-InsCall thrust washer
over end of camshaft.
3.3» 3.14-Install one of the long­
er bolts that retained the engine
gear cover into the counterbalan­
ce alignment hole in gear cover*
Rotate counterbalance while thre­
ading bolt into alignment hole.
When holt engages hole in count­
erbalance and counterbalance vd.ll
not rotate, tighten bolt no furth­
er*
3.3« 3*11-Install cam shaft* Be
careful not to damage bearing and
oil seal* Timing mark on valley
of crankshaft gear must align
\-ri-th timing mark on tooth of caiii-
shafL gear*
3* 3* 3*13-Bcfore the engine gear
cover can be installed, crank­
shaft must be tui.*ned to place
its keyway at 12:00 position
(top dead center of piston)*
3.3-10