Generac Power Systems MC - Manual (Page 58)

3.1» 3,4-Loosoly retain blower hou­
sing support to opposite vibration
damper with capscrew, lockwasher
and flatwasher.
3,1,3,6-Slide exhaust pipe down
through blower housing ^nd through
exhaust pipe u-bolt. Install exha­
ust flange gasket. Retain exhaust
pipe to exhaust flange with an M8
X 50 ram long and an M8 x 20 mm long
socket head capscrew and lockwash-
prs.
3,1,3,^"Retain blower housing and
scroll to blower housing support
(installed in previous step) ^^th
b-20 X ^ inch long bolt and flaL-
washer and a hex nut, flatwasher
and lockwasher. Tighten the hex
nut. Finally, tighten all bolts that
thread into the vlhratlon dampers.
3,1,3,7"Tightcn exhaust pipe u-bolt
hex niiLs,
3,1,3,8"Retaln cylinder head cover
with four MlO X 20 mill long bolts
and lockwashers. Tighten bolts to
12 foot-pounds. TnsLall all No. 10-
32 screws that retain head cover to
blower housing.
3 . 1 - 4