Attaching the starter rope (hardware c), Installation of wheels (hardware e), Final assembly of mower – MTD 113-060A000 THRU 113-062D000 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ATTACHING THE STARTER ROPE (Hardware C)
1. The starter rope is inside the top of the engine.
Additional rope may be wound around the starter han
dle. If so, unwind the rope from the handle.
2. With the spark plug wire disconnected and grounded,
depress the blade control handle and pull the rope out
of the engine.
- 3. Place the rope guide around the starter handle, so the
opening in the rope guide is toward the front of the
mower as shown. Insert the rope guide into the right
side of the handle, and secure with hex lock nut.
FIGURE 7.
INSTALLATION OF WHEELS (Hardware E)
The three holes provide three cutting heights for your
mower. Use the same hole location for all four wheels when
assembling. If wheels are to be assembled In the lowest
cutting position (highest hole in the deck), refer to the note
below.
- If your mower has two sets of holes (see figure 7), the front
wheels must be assembled in one of the three holes near
est the front of the deck. The rear wheels must be assem
bled in one of the three holes nearest the rear of the deck.
To assemble the wheels: (See figure 7)
1. Place axle bolt through wheel.
2. Place one smaller cupped washer on axle bolt, with the
cupped side of washer toward the deck (away from
wheel).
3. Secure wheel to deck with one larger cupped washer
on the inside of the deck (cupped side against the
deck) and hex nut. Tighten securely.
4. Assemble the other wheels in the same manner.
NOTE:
If the lowest cutting position (highest hole in the
deck) is used, it is necessary to place the larger washer on
the outside of the deck and the smaller washer on the
inside.
FINAL ASSEMBLY OF MOWER
1. The chute deflector on your mower is held in an upright
position by a block for shipping purposes only. This
shipping block must be removed and discarded before
------ the mower is put into operation. See figure 8.
To remove the shipping block, move the spring-loaded
chute toward the engine by pushing above the shipping
block. Remove the block and carefully lower the chute
into operating position, keeping fingers out of the way.
2. Make certain all nuts and bolts are tightened securely.