MTD 113-060A000 THRU 113-062D000 - Manual (Page 16)

1 1
TROUBLI: SHOOTING GUIDE
Trouble Possible Cause(s) Corrective Action
Engine fails to start 1. Blade control handle disengaged.
2. Spark plug wire disconnected.
3. Throttle control lever not In FAST
or START posit on.
4. Fuel tank empty, or stale fuel.
5. Blocked fuel lina (if so equipped).
6. Faulty spark pli g.
7. Engine flooded.
1. Engage blade control handle.
2. Connect wire to spark plug.
3. Move throttle lever to FAST or
START position.
4. Fill tank with clean, fresh gasoline.
5. Clean fuel line.
6. Clean, adjust gap or replace.
7. Remove spark plug, dry the plug, and
crank engine with plug removed and
throttle in off position. Replace spark
plug, connect wire and resume starting
procedures.
Engine runs erratic 1. Unit running in START position.
2. Spark plug wire loose.
3. Blocked fuel lina (if so equipped)
or stale fuel.
4. Vent in gas cap plugged.
5. Water or dirt in 'uel system.
6. Dirty air cleanei.
7. Carburetor out' )f adjustment.
1. Move throttle lever to FAST position.
2. Connect and tighten spark plug wire.
3. Clean fuel line; fill tank with clean,
fresh gasoline.
4. Clear vent.
5. Drain fuel tank. Refill with fresh fuel.
6. Clean air cleaner.t
7. Adjust carburetor.)-
Engine overheats 1. Engine oil level low.
2. Air flow restrict« d.
3. Carburetor not .idjusted properly.
1. Fill crankcase with proper oil.
2. Remove blower housing and clean.t
3. Adjust carburetor.t
Occasional skip
(hesitates) at high speed 1. Spark plug gap too close.
2. Carburetor idle mixture adjustment
improperly set.
1. Adjust gap to .030”.
2. Adjust carburetor.t
Idles poorly 1. Spark plug foulad, faulty or gap
too wide.
2. Carburetor impioperly adjusted.
3. Dirty air cleanei.
1. Reset gap to .030” or replace
spark plug.
2. Adjust carburetor.t
3. Clean air cleaner.f
Excessive vibration 1. Cutting blade Icose or unbalanced.
2. Bent cutting blade.
1. Tighten blade and adapter.
Balance blade.
2. Replace blade.
Mower will not
discharge grass 1. Engine speed too low.
2. Wet grass.
3. Excessively high grass.
1. Set throttle between 3/4 and full throttle.
2. Do not mow when grass is wet; wait
until later to cut.
3. Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting swath (1/2 width).
Uneven cut 1. Wheels not positioned correctly.
2. Dull blade.
1. Place all four wheels in same height
position.
2. Sharpen or replace blade.
fRefer to separate engine manual packed with your unit.
Note: For repairs beyond the minor adjustments listed above, please contact your local authorized service dealer.
For Replacement Parts, Contact:
SERVICE DEPARTMENT • P.O BOX 368022 • CLEVELAND, OHIO 44136-9722