Side shield installation, Handle assembly, Note – MTD 218-402-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Insert clevis pin (D) through the tine shield and
depth bar assemblies. Secure with hairpin cotter
—(E). See figure 4.
3. Insert hex bolt (A) into the upper hole of the depth
bar assembly. Place flat washer (B) onto the hex
bolt and thread ball knob (C) onto the hex bolt. See
figure 4. Tighten secureiy.
End Cover
SIDE SHIELD INSTALLATION
Mount side shields (W) over the weld bolts on the end
cover assemblies. Secure with belleville washers (P)
-and hex nuts (Q). See figure 5.
FIGURE 5.
HANDLE ASSEMBLY
1.
Attach the handle panel to the handles using car-
rige bolts (M), lock washer (W) and hex nuts (O).
------ See figure 6. Do not tighten.
FIGURE 6.
NOTE
To align the holes in the handle panel
and the handle, it may be necessary to
loosen the cable brackets which are
mounted to the back of the handles with
self-tapping screws.
NOTE
On Models 402 and 404, handle height
is determined by the three mounting
holes in the handle mounting bracket.
Refer to the adjustment section in your
owner’s manual.