To check, To adjust – MTD 219-250 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ADJUSTMENTS
- (4 H.P. only)
To Check:
Remove Air Cleaner. Move Throttle
Assembly to CHOKE position. The
carburetor choke should then be
closed. Move the Throttle to STOP.
Control lever on carburetor should
then make good contact with stop
switch to short out ignition.
To Adjust:
Place Throttle on equipment in FAST
(high speed) position. Lever “C” on
carburetor should be just touching
choke arm at “D”. To adjust, loosen
casing clamp screw “A” on blower
housing. Move control casing “B”
forward or backward until correct
position is obtained. Tighten screw
“A". Recheck above operation and
replace Air Cleaner.
FORM NO. 770-1.882H
PRINTED IN U.S.A.