Troy-Bilt PONY 664DM - Manual (Page 27)

J
A WARNING
* ri
n'
Before inspecting, cieaning or servicing the machine, shut oft engine, wait for aii moving parts to
come to a compiete stop, disconnect spark piug wire and move wire away from spark piug.
Remove the key from the keyswitch on units so equipped.
Faiiure to foiiow these instructions can resuit in serious personai injury or property damage.
MAINTENANCE SCHEDULE
P R O C E D U R E N O T E S
Check motor oil level 2,3
Clean engine 2,7
Check drive belt tension 1,4
Check nuts and bolts 1,4
Change motor oil 1,4,6
Lubricate tiller 4
Service foam pre-cleaner air filter
(if so equipped) 7
Service paper air filter (if so equipped)
7
Check gear oil level in transmission 1,5
Check tines for wear 5
Check air pressure in tires 5
Service spark plug 7
NOTES
1
- After first 2 hours of break-in operation.
2
- Before each use.
3
- Every 5 operating hours.
4
- Every 10 operating hours.
5
- Every 30 operating hours.
6
- More frequentiy in dusty or dirty conditions.
7 - See Engine Owner's Manuai for service
recommendations.
8 - Whichever time intervai occurs first
TILLER ATTACHMENTS
The attachments listed below are available for your tille Contact your authorized dealer or the factory for current information.
BUMPER — MODEL OEM-290-254
The tubular steel bumper helps to protect the engine from damage.
HtLLER/FURROWER — MODEL OEM-290-251
The furrower blade attaches to the back of the depth regulator assembly and is used to create rows, trenches and ditches up to 8"
deep, depending on soil conditions. The two hlller wings attach to the sides of the furrower blade and are used to make hilled rows
and raised bed gardens.
ROW MARKER— MODEL OEM-290-257
The row marker attaches to the hiller/furrower attachment and is used to scratch lines in the seedbed for laying out furrows,
trenches, raised beds, etc. (eliminates the need for stakes, string and measuring tape). The row marker is adjustable in length from
28" to 49-3/4", allowing you to vary the width of the marked rows as required.