Figure 6.18, Transfer switch isolation method, Figure 6.19 – Generac Power Systems NP Series User Manual
Page 35: Installation with isolation receptacle
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 6 - Installation
INSTALLATION
PRIMEPACT 55C and 55LP Recreational Vehicle Generators
♦ 6.7.6 POWER SUPPLY CORD
The power supply cord must comply with all applicable
codes,
standards
and
regulations.
It
must
be
large
enough to handle the full amperage to which it will be
subjected.
♦ 6.7.7 GROUND FAULT CIRCUIT INTERRUPTERS
The National Electrical Code (NFPA 70, 551-7) requires
that you install ground fault circuit interrupters (GFCIs)
on all external and some internal electrical receptacles.
Contact your manufacturer or dealer for recommenda
tions.
Figure 6.18
—
Transfer Switch Isolation Method
FROM 20 AMP
HACR BREAKER
2ND AIR
CONDITIONER
DOUBLE
POLE
DOUBLE
THROW
SWITCHING
DEVICE
VEHICLE AC
DISTRIBUTION
PANEL
30 AMP
MAIN BREAKER
HACR
BREAKERS
FOR AIR
CONDITIONERS
POWER SUPPLY CORD
Figure 6.19
—
Installation With Isolation Receptacle
DOCKSIDE
POWER
RECEPTACLE
POWER
SUPPLY
CORD
Qenerac* Power Systems, Inc. 33