Remove tiller from crate, Check tire pressure, Handle height – Poulan HDR500H User Manual
Page 7: Assembly
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
ATTACH CLUTCH CABLE (See Fig, 6)
» Hook end of clutch cable through hole in control bar
bracket if necessary.
REMOVE TILLER FROM CRATE
“ Make sure shift lever indicator is in “N’* position (See
Fig. 7)
•
Tilt tiller forward by lifting handle. Separate cardboard
cover from leveling shield.
•
Rotate tiller handle to the right and pull tiller out of
carton.
CHECK TIRE PRESSURE
The tires on your unit were overinfiated at the factory for
shipping purposes. Correct and equal tire pressure is
important for best tilling performance.
•
Reduce tire pressure to 20 PS! (1.4 kg/cm^).
HANDLE HEIGHT
•
Handle height may be adjusted to better suit operator.
(See “TO ADJUST HANDLE HEIGHT” In the Service
and Adjustments section of this manual).
CONNECT SHIFT ROD
(See
Fig.
7)
•
Insert end of shift rod into hole of shift lever indicator.
» Insert hairpin clip through hole of shift rod to secure.