Poulan 210 - Manual (Page 16)

D. CHAIN BRAKE
I .Keep the clutch drum and brake band clean and
free of sawdust, tree sap, and dirt so the brake will
stop the chain in the shortest possible time.
2. Clean the entire mechanism thoroughly every 10
tanks of fuel or every 5 hours of operation, whichever
is less. Do not allow oil or grease to get on the band
or drum. Figure 34.
3. Inspect the assembly for worn or damaged parts
after every time the unit is cleaned. The entire unit
must be replaced when any part is broken, bent, or
damaged in any other way. If an\ portion of the brake
band is less than I/i2" thick, the entire chain brake
must be replaced.
4. Check to see if the brake works properly after any
maintenance. If the chain does not appear to .stop
instantly, the chain brake needs replacement. Any time
the chain brake operation has noticeably changed it
has e.xceeded its sen'ice life and must he replaced.
A
WARNING
The effectiveness of a chain brake in reducing injuries
has not been fully determined. Poulan/Poulan Pro cannot
represent that a chain brake is an effective safety device
to prevent or reduce the hazard of iiyuries resulting from
kickback. Do not assume that the chain brake will pro­
tect you in the event of kickback. Instead, use the saw
properly and carefully to avoid kickback. Proper opera­
tion is outlined in the Operator's Manual. Repairs on the
chain brake must be made by qualified service personnel.
Take you saw/chain to the place of purchase if purchased
from a servicing dealer, or to the nearest Poulan/Poulan
Pro Authorized Master Service Dealer.
E. SPARK PLUG " Replace the spark plug yearly.