beautypg.com

Service and adjustments – Poulan 156332 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

SERVICE AND ADJUSTMENTS

MID-WIDTH TILLING - 22" PATH (See Fsg. 17)

® Assemble holes “A” in tine hubs to holes “C” in tine

NARROW TILUNG/CULTSVATiNG -12-3/4" PATH (See

Fig. 18)

® Remove outer tines.

FIG. 18

NOTE: When reassembling ouiertines, be sure right tine

assembly (marked “R”) and left tine assembly (marked ‘1”)
are mounted to correct side of tine shaft.

TINE OPERATION CHECK (See Fig. 19)

A

WARNING: Disconnect spark plug wire
from spark plug to prevent starting
while checking tine operation.

For proper tine operation, forward tine control lever must be

against control body and all slack removed from inner wire

of control cable when control is in the “OFF” (up) position.

If lever and cable are loose, loosen cable clip at lower end

of cable. Pul! up on cable to remove slack, without

extending spring on end of cable, and retighten cable dip.

FINAL CHECK “OFF” POSITION

» With tine control “OFF” (up), push down on handle to

raise tines off the ground.

<» Slowly pull recoil starter handle while observing tines.

Tines-should not rotate,

» If tines rotate, inner wire of control cable is too tight

which is extending lower spring and engaging tines.

Loosen cable clip and push down on cable only enough

to relieve spring tension. Tighten cable clip.

» Recheck in “OFF” position and adjust if necessary.

FINAL CHECK‘‘ON” POSITION .

» With tine control “ON” (Held down to handle) push down

on handle to raise tines off the ground.

*

Slowiy pull recoil starter handle while observing tines.

Tines should rotate forward.

" If tines do not rotate, inner wire of control cable is too

loose. Loosen cable clip and pul! cable up to remove
slack and retighten dip.

Recheck in “ON” position and adjust If necessary.

NOTE: If “ON” position check required adjustment, re-

check “OFF” position adjustment to insure tines do not

rotate when control is “OFF” (up).

14

This manual is related to the following products: