Assembly instructions – MTD 243-685A User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FLANGE
5.
6
.
Lift up on the housing and rotate it 105° clock
wise. Chute opening should be to the right han "
side
when
viewed
from
the
front
of
unit.
Se.
figure 13.
Place the impeller guard (S) hito flanges on front
of housing. Line up hole in screen with hole on
housing.
Secure
with
one
hand
knob,
belleville
washer and heavy flat washer (H). See figure 13.
FIGURE 13
X
DIRECTIONAL
DISCHARGE
ASSEMBLY (R)
7.
Place the directional dishcarge assembly (R) ove
chute opening. Secure with two hand knobs ana
belleville washers. See figure 14.
FIGURE 14
ASSEMBLY INSTRUCTIONS
for Tow Bar Kit.
1.
Remove the self tapping screws on each side of
frame.
Refer
to
drawing
on
page
12,
reference
number 42.
2.
Place tow bar half in position on frame. Place
one
shoulder
spacer
(U)
between
frame
and
tow bar. Next, place shoulder spacer (U) and hex
bolt (V) through tow bar and frame. Secure with
lock washer (Z) and hex nut (AA). See figure 15.
3.
Secure the two tow bar ends together with he
bolt (W), lock washer (X) and hex nut (Y). Set,
figure 15.