MTD 243-685A User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
f
BbLLEVILLf WASHER (G)
FIGURE 4.
UPPER
HANDLE (O)-
4
i
___ ''
I
HEX BOLT (I)
LOCK NUT (
1. Place nozzle (N) in position on front of housing
so that it rests in flanges. Secure with one hand
knob (F) and belleville washer (G). See figure 4.
2. Place the upper handle (0) in position over lower
handle. Fasten with four
hex bolts (I)
and lock
nuts
(J)
provided.
See
figure
5.
Two
7/16"
wrenches are required.
FIGURE 5.
STUD PIN (K)
3.
Place the stud pins (K) in holes in upper handle
(head of pins go to the inside of handle). Secure
pins
with
push-on
speed
nuts
(L)
by
holding
speed nut with box wrench and tapping pin with
hammer. See figure 6.
FIG U R E 6.