Poulan 157469 - Manual (Page 21)

W i v t i r ANt>
'i* ,b'i. W8'C''i?¥l;|. ¡r.At'Jm.
Adjust the mower while tractor is parked on level ground or
driveway. Make sure tires are properly inflated (See
“PRODUCT SPECIFICATIONS” on page 2 of this manual).
. !!»'. rii ' t i> "^,1
'HiJlii. I I lUWC! .
. 1 « - I ' »-siht- '-i/JI * .'hlLHi (■'Ifc-f lo3fMl Ml
haisb a.cwn.'t<" I* hiyr.eai pr'oi.ioti
' Atthem'dp.,.nic"b^th"!cle&','irfa'‘'a mea^ur., heigr.
frori bottomeuge.itrficw-ertogri,ui«J D>£tan«.e'A rri
both sidPi
0 » rnowprohr.JiiJ be th» -'arop within
of each other.
• If adjustment is necessary, make adjustment on one
side of mower only.
• To raise one side of mower, tighten lift link adjustment
nut on that side.
• To lower one side of mower, loosen lift link adjustment
nut on that side.
NOTE: Three full turns of adjustment nut will change
mower height about 1/8".
• Recheck measurements after adjusting.
FRONT-TO-BACK
IMPORTANT: DEC
ADJUSTMENT
KMUST BELE VELS
Figs. 20 and 2T
IDE-TO-SIDE. IF
THE FOLLOWING FRONT-TO-B/ \CK A.DJUSTMENT IS
NECESSARY,BES URETO A.DJUS>T B01i'H FRONT LINKS
EQUALLY SO M(
TWER WILL S ' 1 A Y 1. .EVEL SiDE-TO'
SIDE.
To obtain the besi i cutting result 3, the mower housinc
-.h iU'dtc >'i,iir
1
p(! • i‘i iltr,» tk.ii'I: r pi / ii 'k Iv !/ >' '
1/2" lower than the rear when the mower is in its highest
¡.O'-iTi
< adju'-irrif rif right -ide > i tm. t'.r u Jk di‘
»antp |kri!i«:-ctl/n'r<-.,itarifth~t indthr in .ndr- -it i-ott-iii
t-rjgp ¡rt'.VJ-'i ticiii. ijiu i>.-. huwfi
• Et-fort m-kiiKjsf r ycc ■jrviku Ini htr ihrd Trd
bothfr-n1 link Jit > quj'iiili ml!» B* il lick 'rniklhf
dppfuKsh lalfcly 1.
• If links are not equal in length, adjust one link to same
length as other link.
• To lower front of mower loosen nut “E” on both front
links an equal number of turns.
• When distance “D” is 1/8" to 1/2" lower at front than
rear, tighten nuts “F” against trunnion on both front
links.
• To raise front of mower, loosen nut “F” from trunnion o n
both front links. Tighten nut “E” on both front links an
equal number of turns.
• When distance “D” is 1/8" to 1/2" lower at front than
rear, tighten nut “F” against trunnion on both front links.
FIG. 20
21