Note – MTD 213-380 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Step 3. Place your foot on the rear of the depth bar

and apply pressure. The belts will go slack.

Step 4-. Remove the REAR belt first and ALLOW IT TO

FORM

LOOP

AROUND

THE

VARIABLE

SPEED PULLEY.

NOTE

By following this order of belt removal,
it is not necessary to remove the belt

guard on the variable speed pulley.

Step 5. Slide the center section of the variable speed

pulley towards the engine.

Step 6. Remove the FORWARD belt from the engine

pulley and the variable speed pulley.

Step 7. Remove the rear belt from the variable speed

pulley.

Step 8. Reassemble with the new belts.

This manual is related to the following products: